Wire Rope Sling Design Requirements

 

1, the actual strength of the buckle break should be at least the minimum corresponding wire rope breakage of 70% of the tension.

 

Note: if the wire rope for metal core, the metal core should be at least three times with, can it is regarded as the bearing part of wire rope.

 

2, in single sling, each end up in make up part of the cable of the minimum distance is not less than 10 times the diameter of the nominal wire rope.

 

Suppress wire rope sling:

 

1, the actual strength of the buckle break should be at least the minimum corresponding wire rope breakage of 90% of the tension.

 

2, suppress wire rope sling with the set of the noose long (refers to joint on the inside edge noose distance) in no set of ring, steel wire shall not be smaller than the nominal diameter 15 times.