| Model | Hose Diameter | Cable Diameter | Length |
| DS-HTSR1 | 1/2 - 1-1/4" | 1/8" (3.2mm) | 20-1/4" (514.3mm) |
| DS-HTSR1(SS) | 1/2 - 1-1/4" | 1/8" (3.2mm) | 20-1/4" (514.3mm) |
| DS-HTSR3 | 1/2 - 2" | 3/16" (4.7mm) | 28" (711.2mm) |
| DS-HTSR2 | 1-1/2 - 3" | 1/4" (6.3mm) | 38" (965.2mm) |
| DS-HTSR2(SS) | 1-1/2 - 3" | 1/4" (6.3mm) | 38" (965.2mm) |
| DS-HTSR4 | 4" | 3/8" (9.5mm) | 44" (1117.6mm)
|
Other Size Can be Customized：
3MM*300 3MM*400 3MM*500 3MM*600
4MM*300 4MM*400 4MM*500 4MM*600
5MM*400 5MM*500 5MM*600 5MM*700
6MM*400 6MM*500 6MM*600 6MM*700
8MM*500 8MM*600 8MM*700 8MM*800 8MM*1000
10MM*500 10MM*600 10MM*700 10MM*800 10MM*1000
Whipchecks hose-to-hose
When hose, couplings or clamps fail, or there is an accidental separation of the assembly, Whipchecks minimize damage to equipment and injuries to operators.
Whipchecks reaches across the hose fittings to provide standby safety for hose, Spring-loaded loops in the cable ends open easily to pass over the couplings for a firm grip on the hose.
Thoroughly tested with years of service, A positive safeguard for air hose connections-helps you meet today's safety standards.
Hose-to-hose or hose-to-rigid outlet.
High resistant to rust and corrosion.
Whipchecks are commonly used on hose for air, water blast, drilling, steam, concrete, sandblast or other high pressure applications.
Prevent injuries or accidents resulting from hose or coupling failure.
Whipchecks should be installed in the fully extended position (no slack) for proper safety assurance.
Hose to hose restraints is slipped over the hose on each side of the fitting and prevent hose whip in the event of fitting separation or failure.
The main materials of wire mesh are stainless steel or galvanized steel.
Types of Whipchecks:
Hose to Hose Hose to Tool
English
